5 ON/OFF

VOLUME

7 TUNE

8 SURROUND
Bedienungsanleitung...3 Instructions for use....11 Notice demploi...19 Istruzioni per luso...27 Instrucciones para el uso....35 Instrues de Uso....43 Gebruiksaanwijzing....51 Kyttohje....59 ....67
Bedienungsanleitung Instruction Manual Notice demploi Istruzioni per luso Instrucciones para el uso Instrues de Uso Gebruiksaanwijzing Kyttohje

RS 130

Konformittserklrung Sennheiser electronic GmbH & Co. KG erklren, dass dieses Gert die anwendbaren CE-Normen und Vorschriften erfllt. Approval Sennheiser electronic GmbH & Co. KG declare that this device is in compliance with the applicable CE standards and regulations. Certification Sennheiser electronic GmbH & Co. KG dclarons que cet appareil est en conformit avec les normes CE. Certificazione Sennheiser electronic GmbH & Co. KG diachiara che questo apparecchio risponde alle normative e alle prescrizioni CE applicabili. Autorizacion Sennheiser electronic GmbH & Co. KG declara que este aparato cumple las normas y directrices de la CE aplicables. Declarao de conformidade A Sennheiser electronic GmbH & Co. KG declara que este aparelho cumpre as normas CE e prescries aplicveis. Vergunning Sennheiser electronic GmbH & Co. KG verklaren, dat dit toestel voldoet aan de toepasselijke CE-normen en voorschriften. Vaatimustenmukaisuustodistus Sennheiser electronic GmbH & Co. KG vahvistaa, ett tm laite on tarvittavien CE-normien ja mrysten mukainen. Sennheiser electronic GmbH & Co. KG CE .
FCC Rules This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1) Reorient or relocate the receiving antenna. 2) Increase the separation between the equipment and receiver. 3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4) Consult the dealer or an experienced radio/TV technician for help. The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Warning: Changes or modifications made to this equipment not expressly approved by Sennheiser electronic Corp. may void the FCC authorization to operate this equipment.
Sennheiser electronic GmbH & Co. KG 30900 Wedemark, Germany Phone +49 (5130) Fax +49 (5130) www.sennheiser.com Printed in China

Publ. 05/05

511733/A02
RS130_GB.fm Seite 11 Freitag, 28. Oktober 2005 9:46 09
The RS 130 is an up-market wireless RF headphone system suitable for use with hi-fi systems and televisions. The headphones are very comfortable to wear and the system incorporates a variety of technical innovations such as: Transmitter with automatic on/off function Automatic transmitter search-tuning with memory function Self-learning automatic level control with memory function Acoustic signals provide feedback on the functions Noise Gate function reduces hissing noise, e.g. during pauses Intelligent battery charging technology Enhancement of the 3D and the bass portion of the stereo signal

Delivery includes

HDR 130 headphones 2 x AAA size Ni-MH rechargeable battery, 1.2 V TR 130 transmitter with audio connecting cable (permanently connected) NT-RS 100 mains unit Adapter 3.5 mm/6.3 mm RCA phono plug (926 MHz variant only) Instructions for use

ENGLISH

RS130_GB.fm Seite 12 Freitag, 28. Oktober 2005 9:46 09

Safety instructions

Never open the transmitter nor the receiver, otherwise you can be injured and the warranty becomes null and void. Attention: Do not wear the headphones in situations which require special attention (e.g. in traffic or when performing skilled jobs). Attention: Listening at high volume levels can lead to hearing defects. Attention: Do not charge standard batteries via the headphones! Only use rechargeable batteries (danger of explosion)! Dispose of exhausted rechargeable batteries at special collection points or return them to your specialist dealer.
Always keep the system dry and do not expose it to extreme temperatures (ideally 1035C). Use the system with care and set it up in a clean, dust-free environment. Varnish or furniture polish may degrade the rubber feet of the transmitter, which could stain your furniture. Do not store your headphones on a glass dummy head, chair armrest, or similar for long periods of time as this can widen the headband and reduce the contact pressure of the headphones. Use a soft cloth for cleaning the units. Do not use abrasive cleaners.

Wall mounting

The transmitter is prepared for wall mounting. The required mounting hardware (screws and plugs) is not included in the delivery.
RS130_GB.fm Seite 13 Freitag, 28. Oktober 2005 9:46 09
Connecting the transmitter (Fig. 1)
Establish the necessary connections (mains unit, audio connecting cable).
The ear cushions are secured to the earcups by means of a quarter turn fastener. To remove an ear cushion, turn it in the direction of the arrow until you overcome a slight resistance and lift it off the earcup.
Inserting the rechargeable batteries (Fig. 4)
Remove the left ear cushion (Fig. 2 and 3). Insert the rechargeable batteries. Attention: Observe correct polarity when inserting the batteries!
Charging the rechargeable batteries
For charging the batteries, place the headphones on the charging cradle of the transmitter. (The headphones automatically turn off during charging.) The red LED CHARGE lights up during the charging process. If the batteries are fully charged, the transmitter automatically switches to trickle charging and the red LED CHARGE flashes slowly. Charge the batteries for at least 16 hours prior to first time use. Subsequent charging time is about the same time as the previous operating time. Always store the headphones on the transmitter to ensure that they are fully charged when they are needed. The intelligent battery charging technology prevents overcharging. If you do not use the head-phones for extended periods of time, please remove the batteries and disconnect the transmitters mains unit from the mains. Nearly discharged batteries will significantly reduce the sound quality. Approx. 10 minutes before the batteries are completely discharged, an acoustic warning signal is produced (two long beeps, see table on page 16).

Removing the ear cushions (Fig. 2 and 3)
RS130_GB.fm Seite 14 Freitag, 28. Oktober 2005 9:46 09
Turning the transmitter on and off (Fig. 5)
Turn on the sound source. This automatically activates the transmitter and the green LED ON/OFF lights up. If the sound source is turned off, the transmitter is automatically deactivated after approx. 3 minutes (the LED ON/OFF goes off).
Note: The automatic level control only functions if the volume of the sound source is sufficient.
Turning the headphones on and off (ON/OFF, Fig. 5)
Move the ON/OFF switch on the headphones to the position ON. The headphones then start the transmitter search-tuning.
Adjusting the volume (VOLUME, Fig. 6)
Use the VOLUME control to adjust the volume on the headphones.
Auto-tuning automatic transmitter search-tuning with memory function (TUNE, Abb. 7)
Note: The transmitter must be activated (green LED ON/OFF lit) and the headphones must be turned on. By pressing the TUNE button or after turn-on, the headphones start scanning the whole frequency range for a transmitter signal. If a transmitter signal is found, the transmitter search-tuning stops and the headphones produce depending on the selected channel one, two or three beeps. The audio transmission then starts. If, for some reason, the signal found is not the correct one (e.g. from another nearby system), press the TUNE button again and the transmitter search-tuning is continued. When turning on the headphones, they automatically start the transmitter search-tuning on the last selected channel. If no transmitter signal is received for an extended period of time (e.g. the range is exceeded or the transmitter is deactivated), six short beeps are produced. After approx. 10 minutes, the headphones automatically turn off. By pressing the TUNE button, the headphones can be turned on again.
RS130_GB.fm Seite 15 Freitag, 28. Oktober 2005 9:46 09
Self-learning automatic level control with memory function
The transmitter is equipped with an automatic level control which ensures that the headphones always receive an optimum signal. The level is continuously adjusted during operation and remains stored as long as the transmitter is connected to the mains.
Under-modulation (audio signal too low)
With under-modulation, the yellow LED INPUT LEVEL flashes slowly. If this happens, gradually increase the volume of the sound source. If the audio signal remains too weak, an optimum transmission is not possible. It could be that the transmitter is deactivated after some time.
Over-modulation (audio signal too high)
With over-modulation, the yellow LED INPUT LEVEL flashes rapidly. If this happens, gradually reduce the volume of the sound source.

Enhancement of the 3D and the bass portion of the stereo signal (Fig. 8)
The RS 130 system is equipped with the so-called sound retrieval system (SRS), which significantly enhances the three-dimensional and the bass portion of the stereo signal. To activate the sound retrieval system, move the slide switch SURROUND on the transmitter to the right. The yellow LED SURROUND lights up.
Automatic noise reduction
In addition, the transmitter features a Noise Gate function, which reduces hissing noise when no audio signal is transmitted (e.g. during pauses).
RS130_GB.fm Seite 16 Freitag, 28. Oktober 2005 9:46 09
Meanings of the LEDs and acoustic signals
Transmitter, LED ON/OFF (green) CHARGE (red) lit Status Meaning Audio signal is present, transmitter is activated Rechargeable batteries are being charged Rechargeable batteries are fully charged, transmitter has switched to trickle charging SURROUND function is activated Audio signal too low Audio signal too high

flashes slowly

SURROUND INPUT LEVEL (yellow)
lit flashes slowly flashes rapidly
Headphones, acoustic signals 6 short beeps
Meaning No audio signal (transmitter is not activated, out of range) Rechargeable batteries are flat Manual or automatic turn-off Headphones tuned to channel 1, 2 or 3
Commentary Automatic turn-off after approx. 10 minutes Automatic turn-off after approx. 10 minutes

2 long beeps

Sequence of 3 beeps 1, 2 or 3 beeps after pressing TUNE
RS130_GB.fm Seite 17 Freitag, 28. Oktober 2005 9:46 09
Turning the acoustic signals (beeps) on and off
The acoustic signals of the headphones can be turned on or off as follows: Turn the headphones on. Turn the headphones off. If the acoustic signals are turned on, the headphones produce a sequence of beeps at turn-off. If no beeps are produced, the acoustic signals are now turned off.
Press the TUNE button for 5 seconds.

If problems occur.

Check if all jack plugs are connected correctly. Make sure that the batteries are charged. Check if the batteries are inserted correctly and that the polarity is correct. Check if the headphones and sound source are turned on and that the volume of the headphnes and sound source is sufficient. Move closer to the transmitter. Choose a different channel on the transmitter. Press the TUNE button again. Reset the system: Remove the rechargeable batteries from the headphones and at the same time interrupt the power supply of the transmitter for at least 30 seconds. Some electronic devices (e.g. televisions) can cause interference, which can be eliminated by increasing the distance between the transmitter and the interference source. Try to operate the transmitter with a different sound source. Should the problem persist, please contact your authorized dealer for assistance.

RS130_GB.fm Seite 18 Freitag, 28. Oktober 2005 9:46 09

Accessories

Additional headphones: HDR 130 (864 MHz) HDR 130 (926 MHz) Replacement ear cushions:
Cat. No. 009932 Cat. No. 009933 Cat. No. 511791
Only use original Sennheiser components and spare parts, otherwise the units can be damaged and the warranty becomes null and void.

Warranty

2-year warranty
Type approval regulations
Please observe the repective country-specific type approval regulations!

Specifications

Modulation Frequency range AF frequency response Signal-to-noise ratio TR 130 transmitter RF output power Power supply Current consumption Channels Connector Weight Dimensions FM stereo see type plate on the bottom of transmitter 18 Hz21 kHz typ. > 68 dBA
< 10 mW (864 MHz variant) < 0.75 mW (926 MHz variant) 9 V DC via NT-RS 100 mains unit < 1.8 VA 3 3.5 mm jack plug (864 MHz variant) RCA plug (926 MHz variant) approx. 430 g (incl. audio connecting cable) width: 85 mm, depth: 133 mm, height: 225 mm (incl. charging cradle)
HDR 130 headphones Transducer principle Max. SPL at 1 kHz THD Power supply Charging time Operating time Weight
dynamic, circum-aural, open 104 dB < 0.5% 2 AAA size Ni-MH rechargeable batteries (LR 03) approx. 16 h (full charge) approx. 22 h (with fully charged batteries) approx. 275 g incl. batteries